New disposal installed under your existing sink, including mounting assembly, plumbing connections, and dishwasher hookup where needed.
Adding a garbage disposal where one didn't exist before means more than just bolting a unit under the sink. It involves connecting the discharge pipe to your existing drain line, aligning the P-trap correctly so it doesn't leak, wiring the unit to a switched outlet or wall switch, and — if your dishwasher drains through the disposal — knocking out the correct dishwasher inlet plug and connecting that line too.
We size the unit to your household before installing anything: a 1/2 horsepower unit is enough for light use, while larger households or heavier daily use are better served by a 3/4 to 1 horsepower motor. Every installation is tested under running water, with the dishwasher cycle run through if applicable, before we consider the job finished.
Tell us what's happening — humming, leaking, or dead — and we'll give you a same-day or next-day appointment window.
A technician identifies the actual cause (jam, seal failure, motor fault, wiring issue) before recommending repair vs. replacement.
You get a clear price before any work begins — repair or new unit installation, no surprise add-ons after the fact.
Most repairs and standard installations are completed in a single visit, using a properly sized unit when replacement is the better option.
Every unit is run under water and tested for leaks, noise, and full drainage before we consider the job finished.
Most disposal repairs cost less than a full replacement — we'll always tell you honestly which one makes more sense for your unit's age and condition.
| Service | Typical Price | What Affects It |
|---|---|---|
| Diagnostic visit / minor repair (reset, jam clearing) | $95–$175 | Most single-visit repair calls |
| Seal, gasket, or leak repair | $150–$275 | Depends on whether the flange or housing seal needs replacing |
| Motor or wiring repair | $175–$350 | If the unit is repairable rather than needing replacement |
| Standard disposal installation (customer-supplied unit) | $150–$250 | Labor only, existing under-sink plumbing |
| Full replacement (unit + installation) | $300–$600 | Varies by horsepower and whether new wiring or plumbing is needed |
Ranges are estimates for typical jobs. Final pricing is confirmed on-site before work begins.
We're adding new cities regularly. Garbage Disposal Installation is currently available in:
San Antonio's municipal water, drawn from the Edwards Aquifer, runs 15–20 grains per gallon of hardness — among the hardest tap water of any major Texas city, and it takes a real toll on disposal motors.
View San Antonio Service AreaHouston Heights was founded in 1891, giving Houston a historic housing district where disposal replacements should account for earlier kitchen alterations and existing drainage.
View Houston Service AreaDallas designated Swiss Avenue as its first local historic district in 1973, highlighting a housing legacy that calls for careful kitchen plumbing assessments.
View Dallas Service AreaFort Worth's Fairmount neighborhood contains a concentration of homes built from 1905 to 1920, making existing kitchen connections an important part of disposal assessments.
View Fort Worth Service AreaAustin Water reported average hardness of 93 parts per million in 2025, a useful reference when investigating mineral deposits and reduced kitchen faucet flow.
View Austin Service AreaEl Paso's Sunset Heights received its name in 1901, and its historic homes make kitchen renovation history relevant when assessing disposal leaks or replacement fit.
View El Paso Service AreaArlington's Old Town Historic District covers nearly seven blocks of early homes, where disposal work should consider previous renovations and existing drain connections.
View Arlington Service AreaCorpus Christi entered Stage 3 drought restrictions in December 2024, underscoring the value of conserving water without operating a garbage disposal with insufficient flow.
View Corpus Christi Service AreaPlano's 2024 water report lists Leonard treatment plant hardness of 112 to 188 parts per million, providing context for checking mineral deposits near kitchen fixtures.
View Plano Service AreaLubbock's 2023 water quality report recorded hardness of 200 parts per million, making mineral deposits worth checking when kitchen faucet flow becomes restricted.
View Lubbock Service AreaLaredo's Barrio Azteca retains buildings from the 1870s, making previous kitchen alterations and existing drain fittings important considerations during a garbage disposal replacement.
View Laredo Service AreaIrving's Heritage House dates to 1912, illustrating the city's older residential roots alongside Las Colinas development and the need to assess actual disposal connections.
View Irving Service AreaGarland's utility FAQ reports average water hardness of 161 milligrams per liter, a useful reference when investigating deposits and reduced flow at kitchen fixtures.
View Garland Service AreaFrisco's report covering 2024 lists Wylie plant hardness of 105 to 202 parts per million, providing local context for mineral deposits around kitchen fixtures.
View Frisco Service AreaMcKinney's Faires House dates to 1854, illustrating the city's long residential history and why older kitchen layouts deserve attention during disposal replacement planning.
View McKinney Service AreaGrand Prairie annexed Dalworth Park in 1942, adding an established neighborhood where disposal replacement should account for kitchen remodeling and the condition of existing connections.
View Grand Prairie Service AreaAmarillo recorded minus 16 degrees Fahrenheit on February 12, 1899, illustrating the severe cold possible when evaluating plumbing exposed to unheated spaces.
View Amarillo Service AreaBrownsville's Stillman House dates to 1850, reflecting a residential history that makes previous kitchen renovations and existing connections relevant when planning disposal replacement.
View Brownsville Service AreaDenton's Oak-Hickory district includes early 1900s residences alongside later ranch homes, making the age of actual kitchen fittings more informative than neighborhood age alone.
View Denton Service AreaKilleen Heights subdivisions were platted during the early 1950s, creating an established housing setting where disposal replacement should include inspection of retained kitchen connections.
View Killeen Service AreaMesquite's utility FAQ describes water hardness ranging from 93 to 134 milligrams per liter, providing context for mineral deposits and restricted kitchen fixture flow.
View Mesquite Service AreaMcAllen's Archer Park was donated in 1917, anchoring a historic downtown where kitchen maintenance should protect drainage while making careful use of water.
View McAllen Service AreaPasadena's Sunset Terrace has a reported average construction year of 1950, making retained kitchen fittings and later renovations relevant to disposal repair assessments.
View Pasadena Service AreaWaco's 2025 water report identifies its drinking supply as 100 percent surface water from Lake Waco, making efficient kitchen water use a practical consideration.
View Waco Service AreaMidland's municipal FAQ reports hardness of 400 to 600 parts per million, making mineral deposits a relevant consideration when evaluating reduced kitchen faucet flow.
View Midland Service AreaRound Rock's 2024 water report lists average hardness of 249 milligrams per liter, providing a dated reference for mineral deposits around kitchen plumbing fixtures.
View Round Rock Service AreaUsually not, if there's already a switched outlet or wall switch near the sink — our technicians handle the standard electrical connection. If new wiring needs to be run to the location, we'll tell you upfront before starting.
Yes — this is one of our most common installation calls. We'll assess your existing under-sink plumbing and electrical setup and let you know if anything beyond a standard installation is needed.
A standard installation typically takes 45–90 minutes, assuming no unusual plumbing or electrical modifications are needed.
Open 7 Days a Week
Call now for same-day or next-day garbage disposal installation — upfront pricing, no surprises.
